Pattern Cut Wood Return Decorative Wall Grille - Pattern O
Pattern Cut decorative Filter Grilles accentuate any room. They can be painted to match your walls or stained to match your trim. These filter grilles come in 26 different designs for you to choose from. They also come in 56 sizes, if you don't see the size you need listed in the drop down menu, call us at 800-504-5989 to get a quote. These wooden grilles are measured by the size of the duct opening in your wall. Measure your return air duct opening width x height. For example, if your duct opening is 10" wide x 6" high you would order a 10 x 6 return air grille. The actual faceplate of the grille will then be 2" larger (in this example the faceplate will be 12" x 8"). These grilles are constructed from a 1/4" thick Baltic Birch ply. For the face of the return air vent, you have the option of choosing between Maple, Oak, or a Cherry Veneer. If you will be painting the grille, the manufacturer recommends you select the maple veneer. They are shipped to you sanded and ready to be finished however you'd like.
Each grille includes a filter frame which is installed in the opening. A dark blue 1" filter is also included with purchase as well as a removable filter door that is held into place with brass thumb screws and all hardware needed for installation.
These beautiful wood filter grilles are made to order, they should ship in 3-5 weeks. Pattern Cut Filter Grilles are special order, non-returnable and cannot be canceled once payment is received.
How to Paint Your Wood Return Decorative Wall Grille
- Select a good shellac, water, oil, or lacquer based primer.
- After thinning the primer, apply 2 thin coats to the surface of the grille with a soft brush.
- Allow the primer to dry completely.
- With a spray, roller, or brush apply 2 coats of paint to the grille.
-Allow to dry before installing the grille.
How to Stain Your Wood Return Decorative Wall Grille
- Submerge the grille in a pan filled with the stain of your choice.
- Allow the grille to dry in an upright position for 24 hours .
- Lay the grille flat and spray it with 2 - 3 coats of lacquer sanding sealer.
- Apply 1 coat to the back of the grille to ensure it is completely sealed.
- Gently sand the grille.
- Lay the grille flat and spray 2 - 3 coats of clear lacquer.
- Allow to cure for 3 days before installing.
Do not use these wood filter grilles in the floor.
Login Status
